DIY cell phone GSM 3G signal booster antenna
Here is a very simple signal booster antenna that you can easily build yourself that improves the signal quality of cell phones, GSM and 3G networks. It only requires a few basic materials that are easy to come by (if it’s not already lying around your house) and could be assembled in less than one hour by the average person. Heck, I did it in less than one hour and also took pictures to share on my blog. The idea for this antenna was passed on to me by my uncle who is a very intelligent guy. He worked out the length for the antenna according to the frequency that most 3G, GSM and cell phone providers use.
Before I show you how to build the antenna, I must stress that I don’t know a lot about frequency's or signals. I only followed the instructions that I received from my uncle to build my antenna. But I am confident that this antenna will boost the signal quality for most devices as I’ve tested it on multiple 3G GSM devices and cell phones.
* 14,15 inch piece of iron wire. (Don’t use copper)
* A 2 piece connector block. (Used to extend electric cables)
* A small bolt and nut that fits through the whole of the “chocolate block.
* 32 feet of coax cable. (Don’t increasing the length of the cable, shortening it is okay thou)
* A piece of water pipe.
* A piece of plastic. (I used an ice-ream container)
Building the antenna GSM booster:
Straiten the wire with pliers and bend it exactly in the center at a 90 degree angle. Measure 3.54 inches from the bend on both sides and bend inwards at 90 degrees. Bend the edges of the wire inwards on both sides again at 90 degrees 3.14 inches away from the last bend.
Insert the connector block to the ends of the wire and tighten it with a screw driver.
Saw one side of the pipe in half and make a whole on the other side in the center. The whole should just be big enough for the bolt to go through. After placing the bolt inside the whole, insert the “chocolate block” on top and tighten with the nut.
Strip the one end of the coax cable and separate the inner and outer wires. Connect the inner wires to one side of the “chocolate block” and the outer wires to the other side.
Place the GSM antenna on your TV antenna pole facing the same direction and lead the cable into the house.
Strip the other end of the coax cable and separate the wires inside again. This time you need to cut away the outer wires since you won’t need them. Take the piece of plastic and cut it in the shape you desire. Make a small hole on one end and stick the inner wire of the coax cable through.
You can wrap the whole thing in tape like I did if you’d like.
Simply place your modem on the piece of plastic or hold the plastic to the back of your phone to boost your signal strength.
My cell phone signal gets boosted to full bars and my GSM 3G modem gets at least one to two bars extra.
Before and after
______________________________________________________________________________
My download speed increased by roughly 15% (upload speed more stable too) and I have a permanent full bar signal since I started to use it about 2 weeks ago.
Here is a very simple signal booster antenna that you can easily build yourself that improves the signal quality of cell phones, GSM and 3G networks. It only requires a few basic materials that are easy to come by (if it’s not already lying around your house) and could be assembled in less than one hour by the average person. Heck, I did it in less than one hour and also took pictures to share on my blog. The idea for this antenna was passed on to me by my uncle who is a very intelligent guy. He worked out the length for the antenna according to the frequency that most 3G, GSM and cell phone providers use.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
01 homemade phone 3g gsm booster antenna |
Before I show you how to build the antenna, I must stress that I don’t know a lot about frequency's or signals. I only followed the instructions that I received from my uncle to build my antenna. But I am confident that this antenna will boost the signal quality for most devices as I’ve tested it on multiple 3G GSM devices and cell phones.
Materials that are required:
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
02 homemade phone 3g gsm booster antenna |
* 14,15 inch piece of iron wire. (Don’t use copper)
* A 2 piece connector block. (Used to extend electric cables)
* A small bolt and nut that fits through the whole of the “chocolate block.
* 32 feet of coax cable. (Don’t increasing the length of the cable, shortening it is okay thou)
* A piece of water pipe.
* A piece of plastic. (I used an ice-ream container)
Building the antenna GSM booster:
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
03 homemade phone 3g gsm booster antenna |
Straiten the wire with pliers and bend it exactly in the center at a 90 degree angle. Measure 3.54 inches from the bend on both sides and bend inwards at 90 degrees. Bend the edges of the wire inwards on both sides again at 90 degrees 3.14 inches away from the last bend.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
04 homemade phone 3g gsm booster antenna |
Insert the connector block to the ends of the wire and tighten it with a screw driver.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
05 homemade phone 3g gsm booster antenna |
Saw one side of the pipe in half and make a whole on the other side in the center. The whole should just be big enough for the bolt to go through. After placing the bolt inside the whole, insert the “chocolate block” on top and tighten with the nut.
Connecting the coax cable:
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
06 homemade phone 3g gsm booster antenna |
Strip the one end of the coax cable and separate the inner and outer wires. Connect the inner wires to one side of the “chocolate block” and the outer wires to the other side.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
07 homemade phone 3g gsm booster antenna |
Place the GSM antenna on your TV antenna pole facing the same direction and lead the cable into the house.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
08 homemade phone 3g gsm booster antenna |
Strip the other end of the coax cable and separate the wires inside again. This time you need to cut away the outer wires since you won’t need them. Take the piece of plastic and cut it in the shape you desire. Make a small hole on one end and stick the inner wire of the coax cable through.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
09 homemade phone 3g gsm booster antenna |
You can wrap the whole thing in tape like I did if you’d like.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
10 homemade phone 3g gsm booster antenna |
Simply place your modem on the piece of plastic or hold the plastic to the back of your phone to boost your signal strength.
Results:
My cell phone signal gets boosted to full bars and my GSM 3G modem gets at least one to two bars extra.
Before and after
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
11 homemade phone 3g gsm booster antenna |
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة] |
12 homemade phone 3g gsm booster antenna |
______________________________________________________________________________
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة]
My download speed increased by roughly 15% (upload speed more stable too) and I have a permanent full bar signal since I started to use it about 2 weeks ago.
[ندعوك للتسجيل في المنتدى أو التعريف بنفسك لمعاينة هذه الصورة]